5 Tier Square Pole Cupcake Tower

5 Tier Square Pole Cupcake Tower - it holds around 60 cupcakes.

The entire size:  Length 350 * Width 350 * Height 421mm 

Tier1: 150mm wide
Tier2: 200mm wide
Tier3: 250mm wide
Tier4: 300mm wide
Tier5: 350mm wide

# 1st,2nd,3rd,4th tier is 4mm thick, 5th tier is 5mm thick . The total height of the Tower is 421mm. 
# The acrylic comes wrapped in the manufactures protective covering

There is no need for glue or other fixings.
The edges of the acrylic are perfectly clear and polished.
Every part of the Tower has been accurately cut and finished
Can be taken apart, washed and stored away for another time.
The Tower comes flat packed and only takes a few minutes to assemble.

We base our numbers on using a 50mm diameter cupcake for our Square range.

 

Assembly Instructions: very simple and quick to assemble. Simply fasten each screw to the corresponding rod, there is no need for glue or other fixings/hardware. View this instructional video on how to put the Maypole Cupcake Tower together.;The four small round plastic feet are included, and you can mix the plates as any plate can be used as top or bottom tier.

PLEASE NOTE: You must remove the manufacturers’ protective cover before assembling this product. This covering is clear bubble and cling wrap on both sides of every acrylic component.

Download Assembly instructions for Square Maypole cupcake Tower

ASSEMBLY GUIDE:

Parts: Acrylic discs, head screws, double screws, acrylic rods and acrylic feet.

* Remove the manufacturer’s protective cover from BOTH side of each acrylic component.
* Begin by placing the feet to the underside of the bottom disc ensuring they are evenly spaced.
* Take a metal head screw and place it on to a flat surface where the Tower is to be constructed
* Carefully line up the hole(s) of the largest disk with head screw ensuring the disc is resting securely on the acrylic feet.
* Now screw the first rod onto the screw thread of the head screw making sure the acrylic disc is clamped firmly between two components.
* Continue by placing the next largest disc on to the screw thread of rod and tighten each piece as you go.
* The final rod is to be used as the supposed for the top tier and the Tower is completed by adding the other screw cap into the top.

CARE GUIDE:

* The Tower is made from acrylic which will scratch if it is not looked after properly. 
* To clean the product use warm water with a little washing-up liquid and soft cloth. 
* Do not use any abrasive cleaning products as they will make the acrylic. 
* Do not put the Tower in a dishwater